Instant Download H12-811_V1.0 Dumps Q&As Provide PDF&Test Engine [Q396-Q415]

QUESTION 396
Which of the following commands can change the device name to huawei? ()

QUESTION 397
The two switches shown in the figure below have both enabled the STP protocol. Which port will eventually be in the Blocking state?

QUESTION 398
After the administrator successfully logged in to the router through Te1net, he found that the router’s interface could not be configuredIP address. Then the possible reasons are ()

QUESTION 399
The configuration information of a certain port of the switch is shown in the figure. Which of the following statements is wrong? () (Single-choice question)

QUESTION 400
It is used to identify wireless networks in WLAN. What distinguishes different wireless networks?

QUESTION 401
The network administrator has captured a data frame in the network, and its destination MAC address is
01-00-5E-A0-B1-C3. What is correct about the MAC address is.

QUESTION 402
Which of the following statements about Prefix Segment is wrong? ()

QUESTION 403
Take effect immediately after the Router ID of the OSPF process is modified ()

QUESTION 404
As shown in the figure below, assuming that the MAC address table of SWA. is as follows, now host A.
sends a data frame with a destination MAC address of MAC-B. Which of the following statements is correct? ()

QUESTION 405
Which of the following statements about IPv6 address configuration is correct? ()*

QUESTION 406
If a windows host is started for the first time, if it uses DHCP to obtain an IP address, what is the source IP address of the first packet sent by this host?

QUESTION 407
The controller is the core component of SDN. The controller is connected to the device through the southbound interface. The following is missing from the controller southbound agreement? ()

QUESTION 408
What are the stable states of OSPF neighbor relationship?

QUESTION 409
Which statement about OSPF area division is wrong? ( )

QUESTION 410
As shown in the figure, the network administrator creates VLAN2 on SWA and SWB. The ports connecting the hosts on the two switches are configured as Access ports. They are assigned to VLAN2. G0/0/1 of SWA and G0/0/2 of SWB are configured as Trunki ports. All VLANs are allowed to pass. What is needed to achieve normal communication between two hosts? () (Single-choice question)

QUESTION 411
In order to distinguish different users and provide different network services on the AP, which of the following can be configured?

QUESTION 412
UDP is oriented to connectionless and must rely on () to ensure the reliability of transmission. ()

QUESTION 413
When using the ping command on the VRP platform, if you need to specify an IP address as the source address of the echo request message, which of the following parameters should be used?

QUESTION 414
NAPT distinguishes the IP addresses of different users through the protocol numbers in TCP, UDP, or IP packets ()

QUESTION 415
In order for the STA to obtain the SSID related information on the AP, which of the following messages is used by the AP to proactively declare the wireless network SSID information?