Free 2024 H12-811_V1.0 Dumps 100 Pass Guarantee With Latest Demo [Q214-Q230]

NEW QUESTION 214
The processing behavior of the data frame received by the switch is ()

NEW QUESTION 215
The output information of a certain router is shown in the figure. Which of the following statements are correct? () (Multiple Choice Questions)

NEW QUESTION 216
Which of the following statements about single-arm routing are correct? ()*

NEW QUESTION 217
The configuration information of a certain port of the switch is shown in the figure. Which of the following statements is wrong? () (Single-choice question)

NEW QUESTION 218
On VRP, the command lines are classified into four levels in increasing priority: Visit level, Monitoring level, Configuration level, and Management level. At which level, the operator is permitted to configure service but is not permitted to operate the file system?

NEW QUESTION 219
What are the advantages of the OSPF protocol? ()*

NEW QUESTION 220
The following description of the Router ID of OSPF is incorrect ().*

NEW QUESTION 221
Which of the following is not the reason why RSTP can increase the speed of convergence? ()

NEW QUESTION 222
What kind of message does the OSPF protocol use to confirm the received LSU message?

NEW QUESTION 223
In the broadcast network shown in the figure, OSPF runs on four routers in the same area and on the same network segment. OSPF will automatically elect one DR and multiple BDRs to achieve a better backup effect.

NEW QUESTION 224
Using a traditional landline to make a call is a way of network communication. ()

NEW QUESTION 225
The number of VLANs that can be created using the commands “vlan batch1020 and “vlan batch10to20” respectively is ()

NEW QUESTION 226
All interfaces of routers running OSPF must belong to the same area.

NEW QUESTION 227
The Layer 2 networking of WLAN refers to STA. It uses AC as its own gateway. ()

NEW QUESTION 228
As shown in the figure below, assuming that the other configurations of the switch are kept in the default state, which port of the following switch will become the designated port? () (Multiple Choice Questions)

NEW QUESTION 229
In the RSTP protocol, when the edge port receives the configuration BPDU message, it loses the edge port attribute.

NEW QUESTION 230
As shown in the figure below, assuming that the other configurations of the switch are kept in the default state, which port of the following switch will become the designated port? () (Multiple Choice Questions)