[Q76-Q98] 2023 Updated NSE7_EFW-7.0 PDF for the NSE7_EFW-7.0 Tests Free Updated Today!

Rate this post

2023 Updated NSE7_EFW-7.0 PDF for the NSE7_EFW-7.0 Tests Free Updated Today!

Fully Updated Dumps PDF – Latest NSE7_EFW-7.0 Exam Questions and Answers

NO.76 View the exhibit, which contains the output of a diagnose command, and then answer the question below.

Which statements are true regarding the output in the exhibit? (Choose two.)

FortiGate will probe 121.111.236.179 every fifteen minutes for a response.

Servers with the D flag are considered to be down.

Servers with a negative TZ value are experiencing a service outage.

FortiGate used 209.222.147.3 as the initial server to validate its contract.

NO.77 Examine the partial output from the IKE real time debug shown in the exhibit; then answer the question below.

Why didn’t the tunnel come up?

IKE mode configuration is not enabled in the remote IPsec gateway.

The remote gateway’s Phase-2 configuration does not match the local gateway’s phase-2 configuration.

The remote gateway’s Phase-1 configuration does not match the local gateway’s phase-1 configuration.

One IPsec gateway is using main mode, while the other IPsec gateway is using aggressive mode.

NO.78 Refer to the exhibit, which shows a FortiGate configuration.

An administrator is troubleshooting a web filter issue on FortiGate. The administrator has configured a web filter profile and applied it to a policy; however, the web filter is not inspecting any traffic that is passing through the policy.
What must the administrator change to fix the issue?

The administrator must increase webfilter-timeout.

The administrator must disable webfilter-force-off.

The administrator must change protocol to TCP.

The administrator must enable fortiguard-anycast.

NO.79 Examine the output of the ‘diagnose ips anomaly list’ command shown in the exhibit; then answer the question below.

Which IP addresses are included in the output of this command?

Those whose traffic matches a DoS policy.

Those whose traffic matches an IPS sensor.

Those whose traffic exceeded a threshold of a matching DoS policy.

Those whose traffic was detected as an anomaly by an IPS sensor.

NO.80 Which two configuration commands change the default behavior for content-inspected traffic while FortiGate is in conserve mode? (Choose two.)

set av-failopen off

set av-failopen pass

set fail-open enable

set ips fail-open disable

NO.81 View the exhibit, which contains the output of a BGP debug command, and then answer the question below.

Which of the following statements about the exhibit are true? (Choose two.)

For the peer 10.125.0.60, the BGP state of is Established.

The local BGP peer has received a total of three BGP prefixes.

Since the BGP counters were last reset, the BGP peer 10.200.3.1 has never been down.

The local BGP peer has not established a TCP session to the BGP peer 10.200.3.1.

NO.82 Refer to the exhibit, which contains the partial output of the get vpn ipsec tunnel details command.

Based on the output, which two statements are correct? (Choose two.)

Phase 2 authentication is set to sha1 on both sides.

Anti-replay is disabled.

Hub2Spoke1 is a policy-based VPN.

Hub2Spoke1 is configured on interface wan2.

NO.83 Which two statements about the Security Fabric are true? (Choose two.)

Only the root FortiGate collects network information and forwards it to FortiAnalyzer.

FortiGate uses FortiTelemetry protocol to communicate with FortiAnalyzer.

All FortiGate devices in the Security Fabric must have bidirectional FortiTelemetry connectivity.

Branch FortiGate devices must be configured first.

NO.84 View the exhibit, which contains the output of get sys ha status, and then answer the question below.

Which statements are correct regarding the output? (Choose two.)

The slave configuration is not synchronized with the master.

The HA management IP is 169.254.0.2.

Master is selected because it is the only device in the cluster.

port 7 is used the HA heartbeat on all devices in the cluster.

NO.85 Refer to the exhibit, which shows the output of a debug command.

Which two statements about the output are true? (Choose two.)

The local FortiGate OSPF router ID is 0.0.0.4.

Port4 is connected to the OSPF backbone area.

In the network connected to port4, two OSPF routers are down.

The local FortiGate is the backup designated router.

NO.86 Examine the output of the ‘diagnose sys session list expectation’ command shown in the exhibit; than answer the question below.

Which statement is true regarding the session in the exhibit?

It was created by the FortiGate kernel to allow push updates from FotiGuard.

It is for management traffic terminating at the FortiGate.

It is for traffic originated from the FortiGate.

It was created by a session helper or ALG.

NO.87 Examine the output of the ‘get router info bgp summary’ command shown in the exhibit; then answer the question below.

Which statement can explain why the state of the remote BGP peer 10.200.3.1 is Connect?

The local peer is receiving the BGP keepalives from the remote peer but it has not received any BGP prefix yet.

The TCP session for the BGP connection to 10.200.3.1 is down.

The local peer has received the BGP prefixed from the remote peer.

The local peer is receiving the BGP keepalives from the remote peer but it has not received the OpenConfirm yet.

NO.88 Examine the output from the ‘diagnose vpn tunnel list’ command shown in the exhibit; then answer the question below.

Which command can be used to sniffer the ESP traffic for the VPN DialUP_0?

diagnose sniffer packet any ‘port 500’

diagnose sniffer packet any ‘esp’

diagnose sniffer packet any ‘host 10.0.10.10’

diagnose sniffer packet any ‘port 4500’

NO.89 Which two statements about bulk configuration changes made using FortiManager CLI scripts are correct? (Choose two.)

When run on the Device Database, you must use the installation wizard to apply the changes to the managed FortiGate device.

When run on the Remote FortiGate directly, administrators do not have the option to review the changes prior to installation.

When run on the All FortiGate in ADOM, changes are automatically installed without the creation of a new revision history.

When run on the Policy Package, ADOM database, changes are applied directly to the managed FortiGate device.

NO.90 The CLI command set intelligent-mode <enable | disable> controls the IPS engine’s adaptive scanning behavior .
Which of the following statements describes IPS adaptive scanning?

Determines the optimal number of IPS engines required based on system load.

Downloads signatures on demand from FDS based on scanning requirements.

Determines when it is secure enough to stop scanning session traffic.

Choose a matching algorithm based on available memory and the type of inspection being performed.

NO.91 Examine the output of the ‘get router info bgp summary’ command shown in the exhibit; then answer the question below.

Which statement can explain why the state of the remote BGP peer 10.200.3.1 is Connect?

The local peer is receiving the BGP keepalives from the remote peer but it has not received any BGP prefix yet.

The TCP session for the BGP connection to 10.200.3.1 is down.

The local peer has received the BGP prefixed from the remote peer.

The local peer is receiving the BGP keepalives from the remote peer but it has not received the OpenConfirm yet.

NO.92 Refer to the exhibit, which contains partial output from an IKE real-time debug.

Which two statements about this debug output are correct? (Choose two.)

The remote gateway IP address is 10.0.0.1.

The initiator provided remote as its IPsec peer ID.

It shows a phase 1 negotiation.

The negotiation is using AES128 encryption with CBC hash.

NO.93 A FortiGate has two default routes:

All Internet traffic is currently using port1.
The exhibit shows partial information for one sample session of Internet traffic from an internal user:

What would happen with the traffic matching the above session if the priority on the first default route (IDd1) were changed from 5 to 20?

Session would remain in the session table and its traffic would keep using port1 as the outgoing interface.

Session would remain in the session table and its traffic would start using port2 as the outgoing interface.

Session would be deleted, so the client would need to start a new session.

Session would remain in the session table and its traffic would be shared between port1 and port2.

NO.94 Examine the output of the ‘get router info bgp summary’ command shown in the exhibit; then answer the question below.

Which statements are true regarding the output in the exhibit? (Choose two.)

BGP state of the peer 10.125.0.60 is Established.

BGP peer 10.200.3.1 has never been down since the BGP counters were cleared.

Local BGP peer has not received an OpenConfirm from 10.200.3.1.

The local BGP peer has received a total of 3 BGP prefixes.

NO.95 Examine the following partial outputs from two routing debug commands; then answer the question below:

Why the default route using port2 is not displayed in the output of the second command?

It has a lower priority than the default route using port1.

It has a higher priority than the default route using port1.

It has a higher distance than the default route using port1.

It is disabled in the FortiGate configuration.

NO.96 Examine the output of the ‘get router info bgp summary’ command shown in the exhibit; then answer the question below.

Which statements are true regarding the output in the exhibit? (Choose two.)

BGP state of the peer 10.125.0.60 is Established.

BGP peer 10.200.3.1 has never been down since the BGP counters were cleared.

Local BGP peer has not received an OpenConfirm from 10.200.3.1.

The local BGP peer has received a total of 3 BGP prefixes.

NO.97 Which statement about the designated router (DR) and backup designated router (BDR) in an OSPF multi-access network is true?

FortiGate first checks the OSPF ID to elect a DR.

Non-DR and non-BDR routers will form full adjacencies to DR and BDR only.

BDR is responsible for forwarding link state information from one router to another.

Only the DR receives link state information from non-DR routers.

NO.98 View the central management configuration shown in the exhibit, and then answer the question below.

Which server will FortiGate choose for antivirus and IPS updates if 10.0.1.243 is experiencing an outage?

10.0.1.240

One of the public FortiGuard distribution servers

10.0.1.244

10.0.1.242

Free NSE7_EFW-7.0 Exam Questions NSE7_EFW-7.0 Actual Free Exam Questions: https://www.prepawaytest.com/Fortinet/NSE7_EFW-7.0-practice-exam-dumps.html

Leave a Reply Cancel reply