Dumps of 200-301 Cover all the requirements of the Real Exam [Q373-Q389]

Rate this post

Dumps of 200-301 Cover all the requirements of the Real Exam

Correct Practice Tests of 200-301 Dumps with Practice Exam

The Cisco 200-301 is associated with the Cisco Certified Network Associate (CCNA) certification. It proves that a candidate has gained invaluable skills and knowledge relating to network administration. Simply put, it is the only test that learners need to pass to obtain the new CCNA.

Q373. Refer to the exhibit.

All interfaces are in the same VLAN. All switches are configured with the default STP priorities. During the STP electronics, which switch becomes the root bridge?

MDF-DC-4:08:E0:19: 08:B3:19

MDF-DC-3:08:0E:18::1A:3C:9D

MDF-DC-08:0E:18:22:05:97

MDF-DC-1:DB:E:44:02:54:79

Q374. How is a configuration change made to a wireless AP in lightweight mode?

SSH connection to the management IP of the AP

EolP connection via the parent WLC

CAPWAP/LWAPP connection via the parent WLC

HTTPS connection directly to the out-of-band address of the AP

Q375. Drag and drop the Wi-Fi terms from the left onto the descriptions on the right.

Q376. Drag the IPv6 DNS record types from the left onto the description on the right.

Q377. Refer to the exhibit.

Which prefix does Router1 use for traffic to Host A?

10.10.10.0/28

10.10.13.0/25

10.10.13.144/28

10.10.13.208/29

Q378. Refer to the exhibit.

Q379. Refer to the exhibit.

When PC-A sends traffic to PC-B, which network component is in charge of receiving the packet from PC-A verifying the IP addresses, and forwarding the packet to PC-B?

Router

Layer 2 switch

Load balancer

firewall

PC–A and PC-B are not in the same network. Switches send traffic in layer 2 and within the same VLA while routers route traffic to different subnet and at layer 3.

Q380. Drag and drop the IPv6 address types from the left onto their description on the right.

Q381. Which type of API allows SDN controllers to dynamically make changes to the network?

northbound API

southbound API

SOAP API

REST API

Cisco overview doc for SDN here: https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Data_Center/VMDC/SDN/SDN.html

Q382. Which type of wireless encryption is used for WPA2 in preshared key mode?

TKIP with RC4

RC4

AES-128

AES-256

Explanation
We can see in this picture we have to type 64 hexadecimal characters (256 bit) for the WPA2 passphrase so we can deduce the encryption is AES-256, not AES-128.

https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/67134-wpa2-config.html

Q383. Refer to the exhibit.

A network engineer must configure R1 so that it sends all packets destined to the 10.0.0.0/24 network to R3, and all packets destined to PCI to R2. Which configuration must the engineer implement?

Q384. Which type of address is the public IP address of a NAT device?

outside global

outside local

inside global

inside local

outside public

inside public

Section: IP Services
Explanation:
NAT use four types of addresses:
* Inside local address – The IP address assigned to a host on the inside network. The address is usually not an IP address assigned by the Internet Network Information Center (InterNIC) or service provider. This address is likely to be an RFC 1918 private address.
* Inside global address – A legitimate IP address assigned by the InterNIC or service provider that represents one or more inside local IP addresses to the outside world.
* Outside local address – The IP address of an outside host as it is known to the hosts on the inside network.
* Outside global address – The IP address assigned to a host on the outside network. The owner of the host assigns this address.

Q385. Refer to Exhibit. Which action do the switches take on the trunk link?

The trunk does not form and the ports go into an err-disabled status.

The trunk forms but the mismatched native VLANs are merged into a single broadcast domain.

The trunk does not form, but VLAN 99 and VLAN 999 are allowed to traverse the link.

The trunk forms but VLAN 99 and VLAN 999 are in a shutdown state.

The trunk still forms with mismatched native VLANs and the traffic can actually flow between mismatched switches. But it is absolutely necessary that the native VLANs on both ends of a trunk link match; otherwise a native VLAN mismatch occurs, causing the two VLANs to effectively merge. For example with the above configuration, SW1 would send untagged frames for VLAN
999. SW2 receives them but would think they are for VLAN 99 so we can say these two VLANs are merged.

Q386. Drag and drop the application protocols from the left onto the transport protocols that it uses on the right

Q387. In a CDP environment, what happens when the CDP interface on an adjacent device is configured without an IP address?

CDP becomes inoperable on that neighbor

CDP uses the IP address of another interface for that neighbor

CDP operates normally,but it cannot provide IP address information for that neighbor

CDP operates normally,but it cannot provide any information for that neighbor

Although CDP is a Layer 2 protocol but we can check the neighbor IP address with the “show cdp neighbor detail” command. If the neighbor does not has an IP address then CDP still operates without any problem.
But the IP address of that neighbor is not provided.

Q388. Refer to the exhibit.

An engineer must configure the interface that connects to PC 1 and secure it in a way that only PC1 is allowed to use the port No VLAN tagging can be used except for a voice VLAN. Which command sequence must be entered to configure the switch?

Q389. Drag and drop the statements about networking from the left onto the corresponding networking types on the right. Not all statements are used.

Explanation:
Controller-based Networking :
– This type deploys a consistent configuration across multiple devices.
– Southbound APIs are used to apply configurations.
Traditional Networking :
– A distributed control plane is needed.
– This type requires a distributed management plane.
On a SND network the control plane is centralized on the the SND controller not distributed on the networking devices.
Northbound APIs do not interact with end devices. They allow the SND controller to interact with applications on the application plane

Loading …

Sample Questions of 200-301 Dumps With 100% Exam Passing Guarantee: https://www.prepawaytest.com/Cisco/200-301-practice-exam-dumps.html

Leave a Reply Cancel reply