Latest [May 12, 2022] 301a Exam Questions – Valid 301a Dumps Pdf [Q57-Q75]

NEW QUESTION 57
Where does a LTM Specialist view all of the objects that are part of a deployed iApp?

NEW QUESTION 58
Refer to the exhibit.

The LTM devices LTM3 and LTM2 have four Traffic Groups defined with approximately the sar of failover objects defined in each group.
– Traffic Groups A and C have Default Device set to LTM1
– Traffic Groups Band D have Default Device set to LTM2.
– Traffic Groups B and C do NOT have Auto Failback enabled. Traffic Groups A and D have Auto Failback enabled with a timeout value of 60 seconds.
– Traffic Groups A and D have Auto Fallback enabled with a timeout value of 60 seconds.
Both LTM devices are healthy and able to pass traffic for any Traffic Group.
LTM1 loses connectivity on interface 1.4. The LTM Specialists notified 60 seconds after the interface goes down.
What is the state of the Traffic Groups on each LTM device?

NEW QUESTION 59
An LTM Specialist configures a new virtual server with a single pool member. The LTM Specialist has NOT defined a health monitor for the pool, pool member or node.
What is the status of the virtual server?

NEW QUESTION 60
An LTM Specialist needs to gather website statistics such as latency and throughput on the existing virtual server. This virtual server load Balances the backend web servers.
Which F5 feature will provide this?

NEW QUESTION 61
An LTM Specialist creates an Analytics wide to show the type of browsers used to access a certain application. However, the generated statistics only sum up all transaction for that application under one item called ‘ Aggregated.” What should the LTM Specialist do to resolve this problem?

NEW QUESTION 62
An LTM Administrator receives an email from the NOC stating that the switch connected to the backend server was shut down for maintenance. The BIG-IP device handles only UDP traffic. The BIG IP device did not fail over to a DR location when no pool members were available.
When the LTM Administrator checks the pool, it confirms that the monitor is still marking UP the pool member.
A tcpdump of the traffic shows the following output:

A list of the monitor configuration shows the following:

Which two modifications to the LTM configuration will mark this pool member down, when the switch is down? (Choose two.)

NEW QUESTION 63
An LTM Specialist needs to create a pool with a set of monitor that checks both the pool members and corresponding application service ports. The pool members have services on port 80. The application service is on port 8009.
The LTM device should load balance traffic to the pool member when the pool member and corresponding application service pass monitor.
Which monitor and parameter set meets this requirement?

NEW QUESTION 64
An unwanted IP address tries to connect to the configuration utility via Self IP An LTM Specialist needs to block the attempts based on the IP address.
How should the ITM Specialist block the attempts without affecting other users?

NEW QUESTION 65
An LTM Specialist needs to use a set of addresses to access an Internet website in an outbound configuration.
Which feature should the LTM Specialist configure?

NEW QUESTION 66
What should an LTM Specialist configure on an LTM device to send AVR notification emails?

NEW QUESTION 67
In an iApp, which configuration protects against accidental changes to an application Services configuration?

NEW QUESTION 68
An LTM Specialist decides to offload SSL traffic on the LTM device instead of just passing it through. The LTM Specialist needs to change the configure from a Performance (Layer 40 virtual server to a Standard virtual server with SSL offload.
Which two element the LTM Specialist consider when performance this task? (Choose two.)

NEW QUESTION 69
Refer to the exhibit.

An LTM Specialist has multiple SNAT and virtual server objects configured as in the bigip.conf shown.
The LTM Specialist tests a connection from a client with. IP 172.163.31.11 to 192.168.0.100:80.
Which two objects will show an increase in Local Traffic statistics connections?

NEW QUESTION 70
A new web application is being deployed Mutual SSL authentication must be used to authenticate clients.
Which of the following two tasks must be completed to meet the requirements? (Choose two)

NEW QUESTION 71
Exhibit.

– The ITM devices LTM 1 and LTM2 are configured in Device Group X (Sync-Failover)
– LTM3 and LTM4 are configured in Device Group Y (Sync-Only)
– An LTM specialist configures Device Group Z (Sync-Only) to keep several profiles in (sync-Only) to keep several profiles in sync across all devices.
– Device GROUP X has four Traffic Groups A, B, C and D configured.
– Device Group Y has four Traffic Groups E, F, G, and H configured
– Auto Fallback IS NOT Enabled.
– Each Device group is healthy and able to pass traffic for any traffic group assigned to that Device Group.
The data center that contains LTM2 and LTM4 loses power. After 10 minutes; power is restored and all devices are up and healthy.
What is the state of each Traffic Group on each ITM device after power is restored?
A)

B)

C)

D)

NEW QUESTION 72
A new HITP server has been deployed on an LTM device. The application running on the server must be monitored by the LIM device. The following is required:
A new HITP server has been deployed on an LTM device. The application running on the server must be monitored by the LIM device. The following is required:
When the server is unavailable, it will send an HTTP status code of 200 in response to a request for the status html page.
When the server is available. I will send and HTTP status code of 201 in response to a request for the status html page.
When the 200 status code is received, the pool member should receive No new connections.
Which configuration change should be made to meet these requirements?

NEW QUESTION 73
Two LTM devices must be manually configured to restrict in the same Device Group.
What is the correct order of steps to meet this requirement?

NEW QUESTION 74
An LTM Specialist has trouble with SNMP traps in the management network The ITM Specialist takes the network capture shown to troubleshoot:

What should the UM Specialist change to capture packets related to this workflow?

NEW QUESTION 75
AN LTM Specialist is deploying an iRule designed to determine the country of origin of an incoming client connection. The iRule needs to be used with an SSL-enabled web application.
Which profile required for the iRule to function properly?