[2022] CTFL-Foundation Answers CTFL-Foundation Free Demo Are Based On The Real Exam [Q97-Q114]

Rate this post

[2022] CTFL-Foundation Answers CTFL-Foundation Free Demo Are Based On The Real Exam

CTFL-Foundation [Oct-2022 Newly Released] Exam Questions For You To Pass

NEW QUESTION 97
Which of the following is NOT a deciding factor in determining the extent of testing required?

 
 
 
 

NEW QUESTION 98
Which of the following statements about test reports are TRUE?
I. Test reports shall be approved by the test team.
II. Test reports shall give stakeholders information as basis for decisions.
III. Test reports shall summarize what happened through a period of testing.
IV. Test reports shall be approved by the development team, the test team and the customer.
V. Test reports shall include information about remaining risks.

 
 
 
 

NEW QUESTION 99
During the software development process, at what point can the test process start?

 
 
 
 

NEW QUESTION 100
Which of the following tool types is the most useful one for a test manager?

 
 
 
 

NEW QUESTION 101
Which of the following is NOT a deciding factor in determining the extent of testing required?

 
 
 
 

NEW QUESTION 102
Testing should provide sufficient information to stakeholders to make informed decisions about the release of the software or system being tested. At which of the following fundamental test process activity the sufficiency of the testing and the resulting information are assessed?

 
 
 
 

NEW QUESTION 103
Which of the following metrics is from the test design phase?

 
 
 
 

NEW QUESTION 104
Which of the test cases below will exercise both outcomes from decision 2? [K3] Refer to the exhibit

 
 
 
 

NEW QUESTION 105
The flow graph below shows the logic of a program for which 100% statement coverage and 100% decision coverage is required on exit from component testing. [K4] The following test cases have been run:
Test Case 1 covering path P,Q,R,U
Test Case 2 covering path P,Q,S,V
Test Case 3 covering path P,Q,S,W,X
Test case 4 covering path P,Q,S,W,Y
Refer to the exhibit

 
 
 
 

NEW QUESTION 106
How many test cases are necessary to cover all the possible sequences of statements (paths) for the following program fragment?
Assume that the two conditions are independent of each other : -if (Condition 1)then statement 1else statement 2if (Condition 2)then statement 3

 
 
 
 

NEW QUESTION 107
Considerable attention will be given in this project to defining exit criteria and on reporting back on their status. Which combination of TWO exit criteria from the list would be best to use? 1 credit
I. Total number of defects found
II. Percentage of test cases executed
III. Total test effort planned versus total actual test effort spent
IV.
Defect trend (number of defects found per test run over time

 
 
 
 

NEW QUESTION 108
Continuing with the Scenario described in the previous question, which of the following topics would you need to address in detail in the master test plan? 3 credits

 
 
 
 

NEW QUESTION 109
Which of the following team roles would be most appropriate to enhance the team and why? 2 credits

 
 
 
 

NEW QUESTION 110
A program controls a switch:
The program has three buttons:
– “ON” to turn the switch ON, or leaves it ON if it were ON.
– “OFF” to turn the switch OFF, or leaves it OFF if it were OFF.
– “Toggle” to change the state of the switch (turn it ON if it was OFF; turn it OFF if it was ON) The following drawing shows drawing shows the state diagram of the program (only the states are marked; the arrows mark possible transitions and are intentionally left unlabeled)

What percentage of the transitions in the State Transition diagram is guaranteed to be covered by the test case given above?
Note: The number of covered transitions depends on the initial state of the switch! Look for the minimum coverage case.

 
 
 
 

NEW QUESTION 111
As part of the improvement program, the organization is also looking at tool support. Which type of tool could be used to ensure higher quality of the code to be reviewed? 1 credit

 
 
 
 

NEW QUESTION 112
Which of the following statements about static analysis are FALSE?
I. Static analysis can be used instead of dynamic testing.
II. Static analysis can uncover defects like security vulnerabilities.
III. Static analysis can be used to check conformance to specifications and standards.
IV. Static analysis typically defects failures prior to component testing.

 
 
 
 

NEW QUESTION 113
Which of the following statements is NOT correct?

 
 
 
 

NEW QUESTION 114
Which of the following statements about estimation of the test effort is WRONG?

 
 
 
 

New 2022 Realistic Free ISQI CTFL-Foundation Exam Dump Questions and Answer: https://www.prepawaytest.com/ISQI/CTFL-Foundation-practice-exam-dumps.html

Leave a Reply

Your email address will not be published. Required fields are marked *

Enter the text from the image below