2023 Realistic NACE-CIP1-001 Dumps Latest NACE Practice Tests Dumps [Q56-Q74]

NO.56 Which is a component that supplies most of the features and functions of the material?

NO.57 What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?

NO.58 An inspectors personal log book should contain:

NO.59 Silicone coatings are typically:

NO.60 Daily reports are important because:
Select All That Apply

NO.61 Osmotic blistering is most likely to occur as a result of

NO.62 Polymerization is the process of:

NO.63 An Inspector should change position when:

NO.64 Good records can provide maintenance departments with detailed information about ALL of the following EXCEPT

NO.65 Dew point is the temperature at which

NO.66 ISO SA 2.5 is defined as:

NO.67 When performing tests for oil and grease using an ultra-violet light, the NACE Inspector should be aware that:

NO.68 When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in SSPC VIS 1 can be used as:

NO.69 ISO ST 3 is described as:

NO.70 According to SSPC PA 2 a Spot Measurement is:

NO.71 Common errors that can produce inaccurate readings when using Wet Film Thickness (WFT) gauges include:
Select All That Apply

NO.72 Which one of these elements is not necessary for corrosion to occur:

NO.73 To be of value the Inspector’s documentation must be:

NO.74 A magnetic pull-off type gauge is a good choice when: