700-905 Certification – Valid Exam Dumps Questions Study Guide! (Updated 52 Questions) [Q29-Q53]

Rate this post

700-905 Certification – Valid Exam Dumps Questions Study Guide! (Updated 52 Questions)

700-905 Dumps are Available for Instant Access using PrepAwayTest

NO.29 Which three features for NVMe transfer protocol are valid? (Choose three.)

Uses PCIe interface

Streamlined commands for fewer CPU instructions

More and deeper queues

Requires 10 controller

Increases memory speed for more lOPs

Improves SAS and SATA speed

NO.30 Which three functionalities are provided by VAAI? (Choose three.)

When a native snapshot is requested, the request is processed by the hypervisor.

Missing pieces of data are re-created from the remaining nodes in service

Cisco HXDP creates a file system native snapshot which is registered in the vSphere.

VAAI performs caching, deduplication: and compression of data.

Instead of the snapshot being performed in hypervisor it is offloaded to Cisco HXDP.

VAAI uses RAID to consolidate disks into a shared data platform.

NO.31 A Controller Virtual Machine (CVM) is an Ubuntu Linux VM that lives outside the converged data platform
on the housekeeping drive since it is involved in creating the convergence data platform Which two features
tor CVMs are valid? (Choose two.)

creates hooks tor services related to third-party abstraction applications

does not perform caching, deduplication: and compression of data

an Ubuntu based VM running in the control space of each individual server, having linear access to the
server’s VMs and networking controls

needs network access to ESXi. other CVMs, and management network

is installed automatically by the HyperFlex installer, configured through the installer

NO.32 Which two ways does Cisco HyperFlex upgrade the traditional RAID? (Choose two.)

HyperFlex enables stretched RAID arrays spanning multiple geographic sites.

Hardware replacement initiates self-healing with minimal impact

Limiting the number of drives locally, which are not a part of the shared datastore.

Distributing data locally, not just across the hosts in HyperFlex cluster

Eliminating the need for additional hardware cards, while maintaining high performance.

NO.33 What is the minimum amount of memory required for an HX node?

192 GB

64 GB

32 GB

128 GB

NO.34 Which version of HXDP was the first to support multiple VICs on a single server?

HXDP 3.5.1

HXDP 3.0

HXDP 4.0

HXDP 3.5

NO.35 Which three additional management tools are included in HXDP to configure HyperFlex clusters? (Choose
three.)

UCS Manager

Storage CLI

Data Center Network Manager

Cisco IMC 13

REST API

HyperFlex Connect

NO.36 Which three additional management tools are included in HXDP to configure HyperFlex clusters?
(Choose three.)

UCS Manager

Storage CLI

Data Center Network Manager

Cisco IMC 13

REST API

HyperFlex Connect

NO.37 Which three features do Managed Deployments provide? (Choose three.)

Great tor managing large deployments, scalability, and oversight of the UCS servers.

Consistent deployment by replicating working configurations from development labs to the production deployment

High availability of the management system and connectivity when using 2 Cisco Fabric Interconnects

Individual configuration of each redundant fabric or global configuration.

Increased operating overhead, raising Operating Expenses (OpEx)

Decentralized yet complex management of an entire UCS domain.

NO.38 Which three functionalities are provided by VAAI? (Choose three.)

When a native snapshot is requested, the request is processed by the hypervisor.

Missing pieces of data are re-created from the remaining nodes in service

Cisco HXDP creates a file system native snapshot which is registered in the vSphere.

VAAI performs caching, deduplication: and compression of data.

Instead of the snapshot being performed in hypervisor it is offloaded to Cisco HXDP.

VAAI uses RAID to consolidate disks into a shared data platform.

NO.39 Which two statements on Replication Factors are valid? (Choose two.)

RF2 has 100% better protection of data while using 33% more space and is recommended.

RF3 has 100% better protection of data while using 33% more space and is recommended.

LAZ can increase RTO for 16+ node clusters.

When performing rolling upgrades, the upgraded node is down for maintenance, stretching RF2 to the absolute limit.

LAZ can decrease fault tolerance of S+ node clusters to less than 4

NO.40 With which three components must every HyperFlex cluster be equipped with in regard to disks? (Choose
three.)

NVMe drives

there are no specific requirements

same type of cache drives

same type and size of capacity of drives

same number of capacity drives

SAS drives

NO.41 Which two processes does failure on a node initiate? (Choose two.)

Distributed pooled data is migrated off nodes to master data store.

Affected node is marked as unhealthy and placed into standby mode

A call-home process is initiated and the failure is reported to TAC

The VMs on the failed node are moved to another node by vSphere high availability

The system is marked unhealthy but remains operational.

NO.42 What is required to cluster a pair of Fabric Interconnects?

uplink connections to the enterprise network

HXDP 3.5.2 or better

connection between the Fl pair using ports L1 and L2

UCS Manager 2.1 or better

NO.43 Which two processes does Disk Failure initiate? (Choose two)

The affected cluster is marked as unhealthy and placed into standby mode

If the replication factor is sufficient for the failure, the system is marked as unhealthy but remains operational

Distributed pooled data is migrated off nodes to master data store.

Performance is almost unaffected Sets 1-minute timer until self-healing starts.

Self-healing mode is initiated and data replication factors applied.

NO.44 Refer to the exhibit.

Which VIC model supports two wire connectivity to each Fabric Interconnect?

VIC 1227

VIC 1557

VIC 1387

VIC 1457

NO.45 Which three configurations for read caching in Cisco HyperFlex are valid? (Choose three.)

Battery-Initiated Read-back (default): Only read data and most commonly used data are deposited in the
Level 4 read-back cache

Write-back (default): Only write information and most commonly used information are deposited in the
cache

Write-through (install option for VDI): Only most commonly used data is cached: optimizing VDI
performance

No caching (SSD): With all-flash nodes; because there is little difference in read speeds between SSDs

Level 4 cached (SSD): With semi-flash nodes; there is a large difference in read speeds between SSDs

Write-first (default for VDI): Infrequently used data is cached: freeing system resources for VDI
performance

NO.46 How much memory is reserved for the controller VM in the HX220c?

48 GB

12 GB

24 GB

78 GB

NO.47 Drag the server type from the left onto the maximum number of capacity drives on the right.

Which three capabilities are provided by Virtual Interface Cards’? (Choose three.)

Virtualizing object storage environments by pushing meta data directly to the management server

The virtual interfaces created by a VIC do not accommodate hypervisor communication like VMkernel
interfaces on vSphere.

Management through Cisco IMC or UCS Manager with dynamic configuration of virtual interface cards
based on the server profile (MAC/WWN).

Traffic processing for internal and external communication supporting simultaneous HBA and NIC
operation on the same physical hardware.

Multiple-interface-card virtualization without any additional driver requirements with integration of the
virtualized cards into the Fabric Interconnect infrastructure.

A virtual environment, such as VMware vSphere, provides VM connectivity via a virtual switch to
individual virtual machines bypassing local hardware requests.

NO.48 Which three configurations for read caching in Cisco HyperFlex are valid? (Choose three.)

Battery-Initiated Read-back (default): Only read data and most commonly used data are deposited in the Level 4 read-back cache

Write-back (default): Only write information and most commonly used information are deposited in the cache

Write-through (install option for VDI): Only most commonly used data is cached: optimizing VDI performance

No caching (SSD): With all-flash nodes; because there is little difference in read speeds between SSDs

Level 4 cached (SSD): With semi-flash nodes; there is a large difference in read speeds between SSDs

Write-first (default for VDI): Infrequently used data is cached: freeing system resources for VDI performance

NO.49 Cisco HyperFlex AII-NVMe nodes are expected to be supported beginning in which HXDP version’?

HXDP 4.0.1

HXDP 3.5.1

HXDP 3 5.2

HXDP 4.0

NO.50 If a GPU card is Installed in HyperFlex nodes before a cluster is created, which action can be used to automatically build the service profile in UCS Manager?

Check Run UCS Manager Configuration during the cluster creation process

Check the extended memory option during the cluster creation process

Check the GPU workflow during the cluster creation process

Check the administrative workflow option during the cluster creation process

NO.51 Which three advantages of using the M5 generation of HyperFlex servers over the M4 generation are valid? (Choose three )

Support for Cisco VICs

Multiple GPUs

M.2 SATA drive support for faster disk I/O

DDR3 memory

Microsoft Hyper-V support

NVMe support

NO.52 Which two components are automatically configured from the information provided to the HyperFlex
installer? (Choose two )

the network

operating system deployment preparation

controller VM configuration

application dependencies

server firmware policy

NO.53 HyperFlex virtual servers differ from regular servers in which two key areas? (Choose two.)

NVMe: Regular servers do not support NVMe drives for high availability.

No RAID is required to consolidate disks into a shared data platform.

CVM: Virtual appliance, which performs reading/writing, caching, deduplication, and compression.

SP: UCS Service Profiles are used to delineate MAC address pools from upstream networks.

CCC: Cisco Cloud Center is used for multi-cloud integration and seamless deployment.

Cisco 700-905 Exam Syllabus Topics:

Topic	Details
Topic 1	HyperFlex products and services by attending training
Topic 2	SE is responsible for defining and engineering related deliverables required to deploy the proposed customer solutions
Topic 3	Identifying staffing requirements, making kickoff meeting presentations Sales team interactions during all product deployment phases
Topic 4	Implement and operate functions Developments in the hyperconverged infrastructure market and Cisco HyperFlex solutions

Cisco 700-905 Exam Practice Test Questions: https://www.prepawaytest.com/Cisco/700-905-practice-exam-dumps.html

Cisco 700-905 Exam Syllabus Topics:

Leave a Reply Cancel reply