Steps Necessary To Pass The PD1-001 Exam from Training Expert PrepAwayTest [Q274-Q288]

NEW QUESTION 274
Toner is attracted to the photoconductor during which of the following stages of the print process?

Developing

Fusing

Transfer

Writing

NEW QUESTION 275
When scanning in color which of the following model is being utilized?

CMYK

Subtractive

Mono

RGB

NEW QUESTION 276
Which of the following electrical components is used to protect against excessive electrical current draw?

Fuse

Resistor

Capacitor

Thermistor

NEW QUESTION 277
How many CCDs are located in a single pass duplex ADF?

One

2

3

4

NEW QUESTION 278
Lines running from lead to trail edge of received faxes would indicate a problem with the:

receiving machines scanner section.

transmitting machines charge section.

receiving machines fuser section.

transmitting machines transfer section.

NEW QUESTION 279
A customer complains that a color device is always calibrating. Which of the following is the BEST explanation about the issue?

The RGB gammas need to be downloaded to the hard drive.

Changes in the environment change color output.

Paper trays need to be adjusted periodically.

The device is updating the network settings.

NEW QUESTION 280
The purpose of a charge coupled device (CCD) array is to convert:

light to a digital voltage.

a digital signal to an analog voltage.

an analog voltage from an 8-bit digital signal.

light to an analog voltage.

NEW QUESTION 281
Which of the following copy defects would result from a single large black spot of contamination on a single mirror?

Overall dark copy quality

Overall light copy quality

Black streaks on the copy

Ghosting on the copy

NEW QUESTION 282
When speaking with a technical support representative, a technician should:

provide minimal information to save the representatives time.

confirm the technical support representatives recommendations.

determine the key contact at the customers location.

explain the customers concerns and clarify their action plan.

NEW QUESTION 283
Toner is fused/fixed to the media by the use of:

a charge roller.

a transfer roller.

heat and pressure.

electrostatic charges.

NEW QUESTION 284
When printing out a color alignment page on a CMYK model laser printer the technician notices that there is a yellow border on the lead edge of the red mixed image and the green mixed image.
There is also a green line between the cyan image and yellow image. Which of the following colors wil need to be aligned?

Cyan

Yellow

Magenta

Black

NEW QUESTION 285
A clients flatbed scanner is constantly producing the same dark spots in the same positions on every scanned page. Which of the following would be the FIRST area to check to solve this issue?

Scan lamp

CCD

White reference plate

Flatbed glass

NEW QUESTION 286
Which of the following failed components will cause an accordion jam in the fuser?

Pawls

Ball bearing

Halogen lamps

Thermistor

NEW QUESTION 287
Toner cartridges should always be disposed of following manufacturers guidelines because toner:

is toxic and can cause serious burns on skin.

is non-biodegradable and has specific disposal guidelines.

emits toxic gases which will harm users.

can cause magnetic interference in other electrical devices.

NEW QUESTION 288
When scanning a document through an ADF the customer notices a thin black line from the lead edge to trail edge of the original. Which of the following is a possible cause of the problem?

Worn feed roller

Corrupt PCL driver

Weak power supply

Contaminated CIS

Leave a Reply Cancel reply