[Oct-2023] Latest Cisco 400-007 exam dumps and online Test Engine [Q157-Q181]

Q157. Drag and drop the multicast protocols from the left onto the current design situation on the right.

Q158. Refer to the exhibit.

Which impact of using three or more ABRs between the backbone area and area 1 is true?

Q159. Refer to the exhibit.

Your company designed a network to allow server VLANs to span all access switches in a data center In the design, Layer 3 VLAN interfaces and HSRP are configured on the aggregation switches Which two features improve STP stability within the network design? (Choose two.)

Q160. A European national bank considers migrating its on-premises systems to a private cloud offering in a non-European location to significantly reduce IT costs. What is a primary factor prior to migration?

Q161. What are two advantages of controller-based networks versus traditional networks? (Choose two.)

Q162. Which DCI technology utilizes a “flood and learn” technique to populate the Layer2 forwarding table?

Q163. Which undesired effect of increasing the jitter compensation buffer is true?

Q164. What are two common approaches to analyzing and designing networks? (Choose two.)

Q165. A small organization of 20 employees is looking to deliver a network design service for modernizing customer networks to support advanced solutions.
* Project scope and weekly progress should be visualized by the management.
* Always consider feedback and make changes accordingly during the project.
* Should consider flexibility to change scope at the point of time.
Which project methodology meets the requirements and have the least impact on the outcome?

Q166. Company XYZ is designing the network for IPv6 security and they have these design requirements:
* A switch or router must deny access to traffic from sources with addresses that are correct, but are topologically incorrect
* Devices must block Neighbor Discovery Protocol resolution for destination addresses that are not found in the binding table.
Which two IPv4 security features are recommended for this company? (Choose two)

Q167. A business requirement stating that failure of WAN access for dual circuits into an MPLS provider for a Data Centre cannot happen due to related service credits that would need to be paid has led to diversely routed circuits to different points of presence on the providers network? What should a network designer also consider as part of the requirement?

Q168. In the case of outsourced IT services, the RTO is defined within the SLA. Which two support terms are often included in the SLA by IT and other service providers? (Choose two.)

Q169. Company XYZ wants to redesign the Layer 2 part of their network and wants to use all available uplinks for increased performance. They also want to have end host reachability supporting conversational learning. However, due to design constraints, they cannot implement port-channel on the uplinks. Which other technique can be used to make sure the uplinks are in active/active state?

Q170. Which two factors provide multifactor authentication for secure access to applications and data, no matter where the users are or which devices they are on? (Choose two.)

Q171. Company XYZ is designing the network for IPv6 security and they have these design requirements:
* A switch or router must deny access to traffic from sources with addresses that are correct, but are topologically incorrect
* Devices must block Neighbor Discovery Protocol resolution for destination addresses that are not found in the binding table.
Which two IPv4 security features are recommended for this company? (Choose two)

Q172. Refer to the exhibit.

Refer to the exhibit A service provider has a requirement to use Ethernet OAM to detect end-to-end connectivity failures between SP-SW1 and SP- SW2 Which two ways to design this solution are true? (Choose two)

Q173. An enterprise network has two core routers that connect to 200 distribution routers and uses full-mesh IBGP peering between these routers as its routing method. The distribution routers are experiencing high CPU utilization due to the BGP process. Which design solution is the most cost effective?

Q174. A healthcare provider discovers that protected health information of patients was altered without patient consent. The healthcare provider is subject to HIPAA compliance and is required to protect PHI data. Which type of security safeguard should be implemented to resolve this issue?

Q175. Drag and drop the end-to-end network virtualization elements from the left onto the correct network areas on the right.

Q176. How can EIGRP topologies be designed to converge as fast as possible in the event of a point-to-point link failure?

Q177. Which two data plane hardening techniques are true? (Choose two)

Q178. Which two types of planning approaches are used to develop business-driven network designs and to facilitate the design decisions? (Choose two)

Q179. Which technology supports antispoofing and does not have any impact on encryption performance regardless of packet size?

Q180. A company plans to use BFD between its routers to detect a connectivity problem inside the switched network. An IPS is transparently installed between the switches. Which packets shold the IPS forward for BFD to work under all circumstances?

Q181. You have been asked to design a remote access VPN solution to support up to 2000 devices. You must ensure that only corporate assets are allowed to connect to the VPN, and users must authenticate to gain access of their based on their user role. Users must use a password that they are already using to access existing applications . A user may not always use the same device to access the VPN. Which two options combined meet the requirements? (Choose two)